Engine Cylinder Head Parts

< this very important bolt , along with the short one is not shown in PET > < we sell them here are a set of 2 pieces because you will need them both > < fits all 924s - 944 - 944 turbo / 951 > < not for the twin cam cars >

This head gasket is made thicker for cylinder heads that have been reconditioned. This is only necessary if the mating surface on your head has fallen below factory spec.To see what the factory specs are on the head go to the tech SECTION OF THE FORUM --...

Complete cylinder head gasket with the wide fire ring head gasket

Bleeder and seal for the water neck.

fits water neck on head

good used - related in clear zinc new hardware and new gasket

 Fits into the water neck at the back of the head.  Pick the one you need form the drop down box. The seal ring is included.

Porsche now have the old type standard cheaper gasket available again !! -- and here it is -- thanks -

t here are 2 types of water outlets please check the one on your 944 and select the correct one from the drop down box above. with or without the hole for the thermo valve

8 needed per cylinder head. All valve guides are oversize. Standard valve guides are no longer available.

8 per engine

< 4 needed per head-unless you buy our rebuilt unit > < 40 mm > < fits all the non turbo 924s 944 from 1982 to 1988 > < also fits the 1983 to 1986 928 4.7 engine > as you know these are VERY difficult to find at the moment we...