if you are going to get the new light trim these are the clips that hold tem in please 1 per side

this soft rubber insert fits around the fuel lines to hold them tight in the plastic clamp

holds the fuel line to the underside of the body check to make sure you have the insert as well

brand new set of clamps for the 924 s / 944 intake boot

< on the underside of the intake boot these is a fitting for a vacuum hose -- this is that fitting > <fits the 924s and- all and the single cam non turbo cars from 1982 to 1989 >

to protect the rear shift leaver

as you see it and comes with the following 5x 2 pin female 4x 2 pin female with pigtail 4x 3 pin female 1x 6 pin female

New and Genuine. This is the plastic trim found in the middle of the outer door handle on Early model 944 and 924 S. was discontinued by Porsche many years ago 'and now its back

aftermarket pin wrench !!

for the later cars you might not need/want the belt tool- so this kits comes with flywheel lock pin wrench 27 mm thin wrench

all you need in one click pin wrench 27 mm thin wrench flywheel lock belt tension tool -- and a new flywheel lock

for a european 89 to 91 944 turbo " whats the difference between the USA and Euro type ? " no idea - but I can bet you its not very much !!!! and this is the MAIN engine bay harness - and NOT the DME harness for the lights- the fans- all the...