Electrical Connectors

This is the female part of the plug - on the harness side-that the reference sensor plugs into - you will need 2 per car. Please go to the FAQ section for installation instructions. The FAQ for this will be in the electrical category. The FAQ section can...

This is the connector that fits onto the injector- you will need 1 per injector.

Brand new factory cable for your 944. This goes between the starter and alternator on your 944. Fits all the 924s 944 944 turbo and the s2 from 85/2 to 1991 -- Its will fit the 968 also - although its a little longer    

< Brand new factory cable for your 924s - 944 - 951 - s2 968 > > This goes between the battery and starter in your 944<>br>And this from a customer -' and its in great form since the battery harness replacement!! Thanks again Ciaran...

This is used for the Air Flow Meter in all 944.

Used for Fuel InjectorsDme Temp Sensor85/2 idle control valve Knock Sensor(Turbo and 16v models only)Hall Sender (16v Models Only)

< new and genuine Porsche > < Used to hold the wiring harness in place in the engine compartment>

< new and genuine porsche > < and sold with a new clamp for the cables >

< as it says - male end connector for the reference sensor > < this is the one on the end of the connector and this end plugs into the 3 pin female end thats on the harness >

Aftermarket reference sensor or speed sensor. Fits all year and model 924s / 944 / 968.  

The Porsche 944 uses a set of single drop brackets to secure the front sway bar. During cornering these brackets flex, and by doing so they reduce the effect of the 944 front sway bar.Our braces bolt between the stock brackets and the cross member to...

This must be spliced into your original harness. 944online is not responsible for any damage resulting from improper splicing.