Here is what is included in this kit 4 - 2 pin fuel injector pigtail kits2 - 2 pin female connector kits3 - 3 pin female connector kits1 - 5 pin female connector kit4 - Heat shrink tubing for pigtailsAll necessary boots and pins are included as well.

This is used for the Air Flow Meter in all 944.

Used for Fuel InjectorsDme Temp Sensor85/2 idle control valve Knock Sensor(Turbo and 16v models only)Hall Sender (16v Models Only)

Easy way to test your oil cooler for leaks. Just pressurize to 30 psi and submerge in a bucket of water. If you see bubbles in the water then it is time for a replacement.

Used to hold adjuster in place while tightening the nut.

Needed to correctly align the oil cooler housing to the engine block.for all engines through 1986 -old style 3 piece valve - or - the new one piece updated type - < the early type without the threaded neck fits all 944 - 82 to 86 including the 86 944...

50ML Squeeze Bottle

Protect your nuts with our soft socket

This is used to properly tension your timing belt when changing your belts.      

< new and your choice > < aftermarket or genuine Porsche > < both are steel >

This is the 12 point tool needed to remove 12 point bolts while working on your 944. They are available in the following sizes. 8mm - CV Bolt10mm - Cam Bolt12mm - Flywheel BoltPlease select the size you need when ordering.

This is a eccentric adjuster used to align the rear axle toe on your 944